Radiolink Electronic Limited
16
/
17
Chapter 4 Image Transmission Instruction
The F110S Image transmission version is not equipped with FPV goggle or screen. Pilots need to
purchase the goggle or screen with integrated 5.8G image transmission.
When receive F110S image transmission version, binding between F110S and FPV goggle/screen
and set the frequency is necessary as the following steps.
1. Take off the cover from the camera on F110S
2. Power on F110S and the FPV goggle/screen
3. Press the button on image transmission and FPV screen/goggle to switch channels until clear
image are shown on the FPV screen/goggle, meaning binding is complete.
The F110S image transmission is from EWRF, having four modes 25mW/100mW/200mW/PitMode.
There are three LEDs at the back of channel switching button.
1
RED and BLUE always on means normal working status with Mode 200mW and channel A1 by
default.
2
If RED is always on while BLUE is off, meaning it
’
s at PitMode. That is mode of
transmission off. The transmission distance is 1-2m. It
’
s advised to choose this mode if there are
many people switching channels simultaneously at the same space as channels won
’
t get mixed.
3
After powering on, long press the channels/power switching button to change
MHz/channel bank/transmission power in row.
4
Long press the channels/power switching button, the RED led flashes once means
entering MHz switching mode. Then short press the channels/power switching button to switch
MHz
（
1-8
）
. BLUE led flashes once means the current MHz is 1. The flashing time of blue led
indicates the corresponding MHz.
5
When MHz is set, long press again the channels/power switching button. The RED led
flashing twice means entering channel bank switching mode. Then short the press channels/power
switching button to switch channel bank( A/B/C/D/E/F). BLUE led flashing once means the current
channel bank is A. Each increase of the blue led flashing indicates the corresponding channel bank.
channels/power switching button
