Radiolink Electronic Limited
15
/
17
Throttle stick back the center position and release , the F110S will hover at this height.
3.5.3 At Altitude Mode: Forward/Backward/Right/Left
At Altitude Mode, you can make F110S fight forward/backwards or towards to right/left by toggling
the right stick at the settled height .
For beginners, make sure to push the stick gently because being a racing drone, F110S is pretty
responsive. It’s advised to release the stick as soon as toggle to one direction so that F110S will
back to level automatically. Otherwise, F110S will keep flying to THE direction with accelerated
speed.
3.5.4 At Altitude Mode: Clockwise/Anticlockwise Rotation
When get familiar with the above flights, try flight clockwise/anticlockwise because the rudder
practice is the more difficult to judge the flight direction. Clearly knowing the direction will quickly
help master drone flight. Try imagine sitting on the drone could be better way to practice.
Push the Rudder Stick ( on the left) to the left and F110S will flight anticlockwise while if push the
Rudder Stick (on the left) to the right, then the F110S will flight clockwise.
3.5.5 At Stabilize Mode
Toggle SwB switch of T8FB to the bottom position and keeps F110S work in Stabilize Mode.
When at Stabilize Mode, F110S will flight faster than when at Altitude Mode. Make sure that the
battery is fully charged before enjoying the flight.
3.6 Low Voltage Alarm
When the green LED on F110S starts flashing during flight means the voltage of F110S is lower than
3.7V as this value is default. It’s advised to stop flying to avoid battery over discharging.
3.7 Note
(1) If this is the first drone flight , set the flight mode as Altitude Hold at low speed, which is much
easier to control comparing with Stabilize Mode. When at altitude hold mode, throttle stick
can be released when F110S rise to a certain height and it will remain at the height. By toggling
the stick on right, F110S will move forward/backward/left/right. When at stabilize mode,
toggle sticks as gentle as possible to avoid drastic movements, which may possibly hurt the
pilot.
(2) Put the throttle stick to the lowest position immediately to stop motors rotating when F110S
knock something.
(3) Make sure the motors are perpendicular to F110S plate.
(4) Make sure the LED of R8FM is blue, meaning R8FM output mode is SBUS signal.
