Revision 0.1 - October 2018
4
CR 915
4. Pairing
To pair the CR 915 Remote Control with the Radioenge RX 915 Receiver:
1. Enter the Receiver's pairing mode pressing the PROG button for 2 seconds (it
is possible to choose wich relay to pair pressing the PROG button once again);
2. In the Receiver, choose through the jumper "Pulso" the pulse's time of duration
(1s, 3s, 5s or retention). The Receiver will then save the setting chosen while
pairing;
Image 2: Jumper to configure the CR 915's pulse's time of duration.
3.
In the remote control, press the buttons
and
simultaneously. The
LED should blink and remain lit. Afterwards, press the button to be paired and
released it right after. The LED should blink rapidly by the end of the process,
indicating the pairing was done successfully.