1205CXB OPERATION MANUAL v1
© Copyright Radiodetection Ltd 2022
12
Basic operation
1.
Charge the 1205CXB using the mains charger and cable supplied, via the USB-A port
2.
Press the Power button
for 2 seconds to power the 1205CXB on
3.
Attach the cable for analysis to the BNC connector, either directly or using one of the
connection cables supplied
4.
Press the
button (Button 5) several times until VOP is highlighted. Change this to
match the VOP of the cable for analysis using the arrow buttons (Buttons 11).
a.
The Left and Right arrows
and
change the VOP by 1%
b.
The Up and Down arrows
and
change the VOP by 0.1%
5.
Press the
button again until Search is highlighted, then press
(Button 12)
6.
The 1205CXB will search for the most significant discontinuity in the cable and place
cursor 2 (Display feature 16) at the start of the reflected pulse
7.
You can read the distance to the discontinuity at the bottom of the display (Display
feature 20)
8.
Press the Power button
at any time to turn the 1205CXB off
NOTE: You can set an Auto Power Off time. For details, see the Menu section
