Radioddity GD-73 Series, Руководство пользователя

Страница: 27 / 120

English user manual - Radiod d ity GD-73 v1.0
Page 26 of 56
If automatic scan is set for a particular channel in CPS, when the user selects
that channel on the GD-73, it will automatically commence scanning of the
scan list attached to that channel.
Start/Stop the scan function
With the CPS, one of the two function keys can be assigned to switch the scan
function on and off ("Scan On / Off"). There are two ways to commence the scan:
1. Use the

or

keys to select a channel which has been programmed for
automatic scan.
2. Press the "Scan On / Off" button pre-programmed with the CPS to start or stop
the scan.
When scanning is enabled, the frequency / channel name of the currently received
channel and its channel properties (analogue, digital and output power) are displayed.
Responding to transmissions found during scanning
If the radio detects an active channel / talk group while scanning, the radio remains on
the channel / talk group for the duration set by the CPS, so you then have the
opportunity to reply to the transmission if necessary.
Procedure
1. Hold the radio vertically, about 2.5 to 5cm from your mouth. If the Channel
Free Indication Tone feature is enabled, you will hear a short beep as soon as
the radio channel is free to prompt you that you can commence transmission.
2. Press the PTT button before the time set by the CPS has expired. The status
LED lights up red.
3. Release the PTT key so that the other station can answer.
4. If you do not respond within the pre-set time, scanning automatically resumes.
Settings
The "Settings" function allows you to specify a wide variety of parameters. Some of
the settings are global, while others refer to the radio channel selected and are
retained even after the radio is turned off.
Information about the radio
You can use the "Local" function menu to read out the ID of the radio as well as
detailed information about the hardware and software of the radio. Navigate to the
menu:
1. Press the MENU key to enter the function menu, then use the

or

buttons
to select the “Settings” sub-menu and confirm your selection by pressing the
MENU button.
2. Use the

and

buttons to select the sub-menu “Local” and confirm
selection by pressing the MENU button again.