Radiocrafts RC16 -SSM Series, Руководство пользователя

Страница: 9 / 20

RC16xxxx-SSM

2017 Radiocrafts AS RC16xxxx-SSM User Manual (rev. 1.00) Page 9 of 20
Radiocrafts
Embedded Wireless Solutions
Module configuration
SSM Configuration Commands
A list of commands is shown in the table below. Commands must be sent as ASCII characters
or their corresponding binary value. All arguments must be sent as binary values to the module
(not as ASCII representation for hex or decimal).
Parameter Comman
d Argument in hex (decimal) Note
Read ID
‘9’ – 0x39 (none)
Returns with 12 bytes: 4
bytes ID (LSB first) and 8
bytes PAC (MSB first).
Configure ID
‘A’ – 0x41 4 bytes ID + 16 bytes KEY + 8
bytes PAC
Set ID, KEY and PAC in non-
volatile memory.
Rewrite PAC
‘B’ – 0x42 8 bytes PAC
Set/Rewrite the PAC in non-
volatile memory.
**Test mode
‘D’ – 0x54 (none)
TX carrier
920,8000 MHz (Domain 3)
902,2000 MHz (Others)
SIGFOX mode
‘F’ – 0x46 0: Only uplink
1: Uplink and Downlink
Data is stored in volatile
memory only.
Write sensor
configuration
‘J’ – 0x4A 100 bytes sensor
configuration array
Write sensor configuration
array. Array must be 100
bytes excactly.
Read sensor
configuration
‘j’ – 0x6A (none)
Read sensor configuration
array. 100 bytes are
transmitted on the UART
Memory
configuration
‘M’ –
0x4D
(Address, Data): see list of
parameters below.
0xFF exits memory
configuration. Used to enter memory
configuration menu.
Parameters changed are
stored in non-volatile
memory.
Signal Strength
(RSSI)
‘S’ – 0x53 Returns one byte indicating
the signal strength of a
detected signal or a valid
packet.
If a valid packet has been
received when in
configuration mode, it will
return the RSSI of the last
received packet.
Temperature
monitoring
‘U’ – 0x55 Returns one byte indicating
the temperature.
See page 12 for details
Battery
monitoring
‘V’ – 0x56 Returns one byte indicating
the power supply voltage.
See page 12 for details
Memory Read
one byte
‘Y’ – 0x59 0x00 – 0x7F
(The argument is the address
in the configuration memory.)
Return one byte value from
the configuration memory.
Exit command
‘X’ – 0x58 (none)
Exit to normal operation
mode. All changes of
parameters take effect.
Test mode 0
‘0’ – 0x30 (none)
List all configuration memory
parameters
Test mode 1
‘1’ – 0x31 (none)
TX carrier:
** 920,1375 MHz (Domain 3)
** 902,1375 MHz (Others)
* 868,1300 MHz