2
Cautions:
• This power console is not a lightning
arrestor and might not protect against
lightning-induced voltage surges.
• Be sure the total wattage of all connected
devices does not exceed 1,800 watts.
• Use the power console only with a three-
prong standard AC plug and outlet or a
grounded two-to-three prong adapter.
The power console cannot provide pro-
tection without a grounded AC source.
• The devices you plug into the power con-
sole must have the same voltage and fre-
quency ratings noted in “Specifications”
on Page 3.
CONNECTIONS
1. Ensure the power is off by pressing the
power console’s
MASTER
switch up so its
green edge does not show.
2. Connect the following to the power con-
sole:
• Your computer’s CPU to the
MASTER
outlet
• Your monitor to the
MONITOR
outlet
• Your printer to the
PRINTER
outlet
• Other devices to the
AUX 1
,
AUX2
, and
UNSWITCHED
outlets.
Note: The
UNSWITCHED
outlet sup-
plies power even when the
MASTER
switch is off, but it only provides neu-
tral-ground surge protection.
• To connect a telephone or fax, connect
a modular telephone cord (not sup-
plied) from the power console's modu-
lar
LINE IN
jack to a standard
telephone wall jack. Then connect the
power console's modular
LINE OUT
jack to your fax, modem or telephone
with the supplied modular telephone
cord.
3. Plug the power console’s AC power cord
into a three-prong standard AC outlet.
Your power console also serves as a monitor
stand. Align the mounting grooves at the front
of the extension with the ribs at the back of the
power console, then press the extension
down to lock it in place. Place your monitor on
the top of the power console.
OPERATION
1. When all connections are complete, turn
on the power console by pressing down
the
MASTER
switch so the green edge is
exposed. The green SURGE PRO-
TECTED indicator lights.
2. Press down the corresponding switches
to turn on the connected devices.
When the power console receives a cur-
rent that exceeds its capacity due to over-
load, the 15-amp circuit breaker (located
on the side of the case) breaks to prevent
possible damage, and the red reset
plunger pops out. To reset the power con-
sole, disconnect one or more of the con-
nected devices and allow the power
console to cool down, then push in the
reset plunger.
3. To turn off the power console’s power,
press the
MASTER
switch up. The
SURGE PROTECTED indicator remains
Monitor
Printer
AC Outlet
Telephone
Wall Jack
Telephone
CPU
Other
Device
61-2350.fm Page 2 Thursday, November 30, 2000 10:47 AM