25
EN
10.1 Test run / modifying the end points
1.
Check the direction of travel of the motor. Switch
the lines for the rotation direction if required, see
connection diagram
[ 26 ]
on page 21.
2.
Check the settings and allow the roller shutter to
run in both directions, until the end points switch
off the motor.
Modifying the end points
Move the roller shutter back to the centre position
and begin the process again.
ATTENTION!
The tubular motors are designed for transient
operation (approx. 4 min.).
If this period is exceeded, or if the equipment is
switched over frequently, then the motor may heat
up and the thermal protection system will switch
it off.
In this case, allow the motor to cool down for 20
minutes.
11. Reloading the factory settings
Self-learning mode with a smooth stop is active
again after loading the factory settings.
Notes for carrying out the setting
In order to carry out this setting, it is necessary to
connect the two control lines for up ( ) and down
( ) separately to the phase
( L )
.
Either use a new commercially available universal
setting cable
(21)
or the older cord-switch setting
unit or an external button with two switching
contacts.
The tubular motor may not be in operation.
Factory settings:
End points:
no end points stored
Self-learning mode with
smooth stop:
activated
Proceed as follows:
1.
Connect both directions of travel to the mains supply for approx. 5 seconds until
the tubular motor confirms this by briefly running up and down.
2.
Switch off the mains power supply and reset the original connection in accordance with the connection diagram
[ 26 ]
on page 21 if you have carried out the setting with the universal setting cable or with a cord-switch setting unit.
Switch
button 1
to any position and press
button 2
(set button)
when using the universal setting cable
(21)
.
Please press the ON switch and SET button at the same time when using a
cord-switch setting unit.
Please press both buttons at the same time when using an external button.
After that the factory settings are loaded.
5 sec.
