RADEMACHER RolloPort S2, Перевод оригинального руководства по эксплуатации и сборке

Страница: 18 / 36

(A) Installation of the header bracket (1)
NOTE
The header bracket (1) must be aligned with the mid-
point of the door.
Key
1
= Header bracket
2 = Screw (6 x 80 mm) with hexagon nut
3 = Hexagon screw (8 x 60 mm)
4
= Rail
1.
1 2
3 4
Mark out the position of the header bracket
(1) and drill the mounting holes (e.g. with a
10 mm masonry drill bit).
Screw the header bracket (1) tight with the
enclosed hexagon screws (8 x 60 mm).
Then fix the rail (4) with the enclosed
hexagon screw (6 x 80 mm) to the header
bracket (1).
(B) Installation of the fixing bracket (5) at the door operator head (7)
1. Push the fixing bracket (5) onto the rail (4), as
close to the door operator head (7) as possible.
Mark the mounting holes for the fixing
bracket (5).
In order to do so, lift the entire construction and push
it against the ceiling.
NOTE
Ensure that the rail (4) is aligned with the centre of
the door.
Drill the mounting holes (e.g. with a 10 mm
masonry drill bit).
Finally screw the fixing bracket (5) to the ga-
rage ceiling with the enclosed hexagon screws
(8 x 60 mm).
5
6
3.
7
4
Key
4
= Rail
5
= Fixing bracket
6 = Hexagon screw (8 x 60 mm)
7
= Door operator head
4.
2.
3.
2.
18
EN