27
EN
i
1.
Ensure the mains are current-free and check whether the
inlet leads are current-free.
2.
Securely lay the connecting cables right into the flush-mounted
box.
3.
Remove the insulation on all leads down to 6 mm in length and
connect them according to the following connection diagram.
4.
After the electrical connection, the installation of the Troll Basic
5602 into the flush-mounted box is carried out, see page 29.
9.1 Connecting a tubular motor
Connecting the white set cord (SET) from RADEMACHER
tubular motors
The white set cord
(SET)
from RADEMACHER tubular motors
must be connected to the neutral terminal
[ N ]
to ensure
trouble-free operation of the tubular motor.
