RADEMACHER 3250 13 71, Инструкция по электрическому подключению и пусконаладке

Страница: 62 / 72

62
EN
18.7.5 Menu 9.8.9 - Configuration of end points for the tubular motor
You can use your DuoFern HomeTimer to configure the end points for an electronic
RADEMACHER tubular motor.
1. Select and open menu 9.8.9 - End points .
2.
Select a DuoFern actuator. [ ALLE ] (ALL) is
is not possible for this function.
3. Set the upper end point .
a) Press and hold the set button. The roller
shutters travel upwards.
The upper end point is thereby stored for
the motor.
a)
You can send a brief test signal in order to
identify the DuoFern actuator.
The actuator executes
a brief movement or
switching command by
way of confirmation.
b)
Release the button as soon as the desired
end point is reached.
i
The end point setting function is only available for RADEMACHER electronic tubular motors
from 2000 onwards.
The end point setting can not be adjusted for tubular motors connected in parallel.