and within 3 seconds the unit will give a confirmation tone indicating the volume level is set and
stored in the unit’s memory. To change again the volume level, simply repeat this step once again.
Radar Mute Setting:
The Radar mute settings is designed to mute all Radar and Laser audio alerts at a particular driving
speed, this feature is particularly helpful when one drives at low speeds in city where there may be
Radio Frequency interferences present such as from automatic door openers and security alarms, whom
operate on the very same frequency the police Radar equipment is often used.
To change the mute speed simply press the Menu button once and scroll using the UP/Down buttons to
set for the desired mute speed, when done simply let of the button and within three second the unit will
give a confirmation tone indicating the setting was successfully stored in the units memory .
If you wish to change the settings again simply repeat the above described process.
Note: When the Radar Mute setting is active the unit will still provide accurate visual alert by the display
so you will still be able to know of such detected frequencies. The default speed from the manufacture is
set to 15 MPH.
Working Mode Setting (Optional):
The working mode setting allows you to select between the “Camera Detector Mode “and “Safe Drive
Mode”, both modes are based on our GPS based database. The Camera Detector Mode will cover all
speed cameras, red light cameras, speed enforcements cameras, speed enforced modes and common
speed trap locations. The Safe Drive Mode will cover all the above plus additional safety warnings such
as, School Zones, One Way Streets, Toll Stations and more (see attached alert type mode and type for
more information).
Radar Signal Detection Setting:
The radar signal detection setting allows you to select between City, Highway and / or powering the
Radar detection option off. The change between settings simply use the Up/Down buttons , when the
desired setting is reached simply let off the button, within three seconds the unit will give a confirmation
tone indicating the setting was successfully stores in the unit’s memory, to make and further changes
simply repeat the above described process.
Cruse Seep setting:
The Cruse speed setting was design to alert drivers when they drive over a particular speed and my not
notice it, this feature is very useful particularly on long driving roads such as on highways where the
speed limit is usually the same and the driver may wish to set the unit to warn him if he goes over the
speed limit of that road.
To change the desired speed alert simply use the Up/Down buttons to reach the desired speed, once the
desired speed is reach simply let off the button and within three second the unit will give a confirmation
tone indicating the desired speed was successfully stored in the units memory.
To change the above settings, simply repeat the above described process.
