RACOM RipEX2, Руководство пользователя

Страница: 82 / 248

Mode of Connected device: SLAVE
Response timeout [ms]
Number {0 – 16383}, default = 1000
COMLI protocol response timeout is used for waiting on COM port for the response of connected
device.
Response target mode
List box {LASTRCV; TARGET}, default = ”LASTRCV”
Slave response will be sent to the address of the last received request (LASTRCV) or to the
specified
Response target IP address (TARGET).
7.1.3.3.5. DNP3
Each frame in the DNP3 protocol contains the source and destination addresses in its header, so there
is no difference between Master and Slave in terms of the RipEX2 configuration. The DNP3 allows
both Master-Slave polling as well as spontaneous communication from the remote units.
The common parameters (e.g. address translation) shall be set.
Broadcast
List box {On; OFF}, default = "On"
Note
There is not an option to set the Broadcast address, since DNP3 broadcast messages al-
ways have addresses in the range 0xFFFD - 0xFFFF. Hence when Broadcast is On,
packets with these destinations are handled as broadcasts.
RipEX2 Radio modem & Router – © RACOM s.r.o. 82
Settings