RACOM RipEX2, Руководство пользователя

Страница: 80 / 248

Response target mode
List box {LASTRCV; TARGET}, default = "LASTRCV"
Response for the incoming frame shall be directed to the IP address of the Master who sent the
frame (LASTRCV) or to a specified IP address (TARGET).
Response target IP
IP address to which the response is sent when TARGET is chosen in the Response target mode.
7.1.3.3.1. None
The None protocol switches the COM port off. All incoming data will be thrown away, No data will be
send into the COM interface.
7.1.3.3.2. Transparent protocol
Operates in Bridge mode only. All the traffic is bridged transparently to RipEX2 network (see Section 5.1,
“Bridge mode” for details).
7.1.3.3.3. Async link
Async link creates an asynchronous link between two COM ports on different RipEX2 units. Received
frames from COM port or from a Terminal server are sent without any processing transparently to Radio
channel to set IP destination and UDP port. Received frames from Radio channel are sent to COM or
Terminal server according to Destination (UDP port) parameter.
Destination IP
This is IP address of destination RipEX2, either ETH or Radio interface.
Transmit as broadcasts
List box {On; Off}, default = "Off"
Allows sending of the packets incoming from COM port as broadcast.
Accept broadcasts
List box {On; Off}, default = "Off"
On: Broadcast packets from the radio channel will be send to the COM port.
Off: Only unicast packets will be sent to the COM port.
RipEX2 Radio modem & Router – © RACOM s.r.o. 80
Settings