RACOM RipEX2, Руководство пользователя

Страница: 111 / 248

Note
Informational note. It is a good practice to enter some descriptive area name since this value is
displayed (when filled) instead of the
Area ID as an Area name in other configuration dialogs (e.g.
Networks configuration).
7.2.3.4. Network - Areas and interfaces - Interfaces
OSPF interfaces of the respective OSPF area are defined here. Maximum number of interfaces is 128.
Active
List box {On; Off}, default = "Off"Enables / disables the interface.
Interface
String {a..z A..Z 0..9}, max 16 char, default = <empty>OSPF interface name. Name of an existing
unit interface has to be used. Following interfaces can be used:
• LAN – “if_” prefix must be used followed by Network interface name, e.g. “if_LAN-141”
• VLAN – “if_” prefix must be used followed by Network interface name, ‘.’ dot and VLAN number,
e.g. “if_LAN-141.29”
• Radio – “radio”
• Hot standby – “hstdby”
• GRE L3 – “gre_tunX” where ‘X’ is the tunnel number, starting from zero
• Cellular – “aux”
Network IP / Network mask
IP address and mask of the address range above which the OSPF protocol will be working on this
interface. The default value is 0.0.0.0/0, which means the whole address range on this interface is
available for the OSPF protocol.
Network type
IP address and mask of the address range above which the OSPF protocol will be working on this
interface. The default value is 0.0.0.0/0, which means the whole address range on this interface is
available for the OSPF protocol.
Cost
Number {1 – 65535}, default = 10 The cost of traffic over this interface. The higher the Cost, the
worse the path. It is added to OSPF metric ‘Type 1’.
Hello interval
Number {1 – 3600}, default = 10Interval (in seconds) of sending Hello packets. The interval must
be the same for the all participants of the given interface.
Poll interval
Number {1 – 3600}, default = 20Interval (in seconds) of sending Hello packets to inactive neighbors
in the NMBA type of interface.
Retransmit interval
Number {1 – 3600}, default = 5Interval (in seconds) of repeating unacknowledged packets.
111 © RACOM s.r.o. – RipEX2 Radio modem & Router
Settings