5.5. Switch settings
Ethernet switch is a key part of the unit. It is responsible for data transfer inside the unit - see
5.5.1. Status
5.5.1.1. Port status
The unit internal Ethernet switch port status
Fig. 5.17: Menu Switch settings > Status > Port status
Port name
Identification of the internal switch port. The switch ports are connected to an external port or to an
internal device (radio modem, management CPU).
• Eth1 (port1) — The external port (with RJ45 interface) labeled "ETH1+POE".
• Eth2 (port10) — The external port (with SFP interface) labeled "ETH2".
• CPU (port0) — The internal port to management CPU.
• Air (port9) — The internal port to radio modem, i.e. link to the peer unit.
Link status
Ethernet link status can be
• down — no link signal detected
• up — link signal detected
Speed / duplex
Ethernet link Speed and duplex.
• Speed: — 0/100/1000 Mbps.
• Duplex: — full/half
SFP info
Information about the (optionally) inserted SFP module - see
Section 1.3.2, “SFP slot (ETH2)”
for
info about available SFP modules. Four situations may appear:
• SFP OK — The SFP vendor string read out of SFP module. The vendor, model, connector
(RJ45/LC) and wavelength values are shown. Separate window with more detailed information
can be opened by clicking the "more..." link.
• No SFP module — SFP module not inserted
• read error — SFP info can not be read
• no SFP option — n/a
RAy3 Microwave Link – © RACOM s.r.o.
108
Configuration
Содержание RAy3-11
Страница 2: ......