910198 – Tie Tamper
Phone: (262) 637-9681
11.2019 Rev 1.1
Page
7
of
21
Section 2: Specifications and Installation
Specifications
Pressure Range .................................................................................................. 1500-2000 psi /106-140 bar
Maximum Back Pressure ....................................................................................................... 200 psi / 14 bar
Flow Range (5-GPM Models)....................................................................................... 4-6 GPM / 15-23 LPM
Flow Range (10-GPM Models)................................................................................... 7-10 GPM / 26-38 LPM
Porting ....................................................................................................................................... -8 SAE O-ring
Connect Size and Type ..................................................................... ...............3/8 in. Male Pipe Hose Ends
Connector ........................................................................................................... HTMA Flush Faced Coupler
Hose Whips ....................................................................................... ........................................................ es
System Type .................................................................... EHTMA Category C/HTMA Type I - Open Center
Weight (w/Steel) .......................................................................................................................... 56 lb / 25 kg
Overall Length (w/Steel) ............................................................................................ 39.75 inches / 100.9 cm
Overall Width............................................................................................................. 14/17 inches / 35.6/44 cm3
Sound Power and Vibration Declaration
Test conducted on the Tie Tamper and operated at standard 5 GPM input.
Measured A-weighted sound power level, Lwa (ref. 1pW) in decibels ............................................. 106 dBA
Uncertainty, Kwa, in decibels ............................................................................................... .................3 dBA
Guaranteed sound power level ............................................................................................... ..........109 dBA
Measured A-weighted sound pressure level, Lpa (ref. 20 µPa) at operator’s position, in decibels .... 98 dBA
Uncertainty, Kpa, in decibels ............................................................................................... .................3 dBA
Values determined according to noise test code given in ISO 15744, using the basic standard ISO3744.
Test conducted by independent notified body to comply with 2000/14/EC:2005 requirements.
Note:
The sum of a measured noise emission value and its associated uncertainty represents an upper
boundary of the range of values which is likely to occur in measurements.
Declared vibration emission value in accordance with EN 12096
Measured vibration emission value: 3-Axis .............................................................................. ..... 6.3 m/sec²
Uncertainty: K ................................................................................................ ................................... 1 m/sec²
Measured vibration emission value: Z-Axis ............................................................................. .........3 m/sec²
Uncertainty: K ................................................................................................ .................................0.7 m/sec²
Values determined according to ISO 8662-5, ISO 5349-1,2