910161
Hydraulic Rail Drill
Phone: (262) 637-9681
Email:
1.2023 Rev 3.1
Original Instructions
Page 16
Section 3: Tool Operation
Personal Protective Equipment
Before operating this machine, make sure that all general safety precautions are observed,
and that proper personal protective clothing is worn as described below.
At a minimum, operators should wear the following Personal Protective Equipment:
1. Safety Glasses
2. Hearing Protection
3. Hard Hat
4. High Visibility Safety Vest
5. Leather Work Gloves (outside the cab)
6. Steel Toed Safety Shoes
Pre-Operation
Accidental tool start can cause serious personal injury
.
Do not
install or remove tool attachments on a tool that is connected to
a hydraulic power source.
Tool and attachment may be hot. Hot surfaces can cause serious
bodily burns. Use caution when working around these
components.
Worn or damaged attachments may fail during use and cause
severe personal injury
.
Discard tool attachment if any cracks,
chips, or gouges are present.
Bit may fail dur
i
ng use, potentially causing severe personal injury. Some bits with a long spiral or wide
flute spacing may not be acceptable for use with this tool.
Drill test holes to determine if bit whips, bends under side-load, or lunges forward at breakthrough
.
Do
not use a bit that behaves as above.
1.
Inspect the quick change chuck. Remove any dirt or other contamination that may have
accumulated in the chuck.
2.
Slide and hold quick change chuck away from tool and remove drive shank
3.
Insert desired bit into hex socket of tool and release chuck
.
4. To remove drill bit, slide and hold quick change chuck away from tool and remove bit.
