910103
Hydraulic Rail Profile Grinder
Phone: (262) 637-9681
Email:
9.2023 Rev 2.4
Original Instructions
Page
7
of
21
Always
comply with all instructions provided on any decals or placards installed on the machine and with
any relevant amplifying information provided in this manual or other general operating procedures.
Always
read all tags and decals attached to the tool by the factory. Read and understand all tags before
removal or before operating the tool. Do not exceed the tools rated flow and pressure at any time.
Always
replace worn or damaged tags and decals. The information on them should be legible at all
times. Replacement tags and decals are available from your Racine Railroad Products distributor.
Always
disconnect the power source and make sure that all controls are in a safe position and install all
appropriate locking and safety devices before doing any of the following:
•
Lubricating
•
Adjusting
•
Installing Tooling
•
Making Repairs
•
Performing Service
Section 2: Specifications
Specifications
Maximum Flow .............. 10 gpm / 40 lpm
Maximum Pressure ....... 2000 psi / 140 bar
Maximum Wheel ........... 3 in X 6 in
Arbor Hole Size ............. 5/8-11 Threaded
Hydraulic System .......... Open Center
Length: .......................... 45.5 in / 115.5 cm
Width: ............................ 16 in /40.6 cm
Height: ........................... 35 in / 88.9 cm
Weight: (less stone) ...... 110 lbs / 49.9 kg
