GNSS
The top area of the setup page displays the GNSS engine status information including the latitude, longitude, GNSS fix
status, RTK age in seconds, satellite count and constellations used. Selecting the '
Change settings
' button next to the
GNSS heading will open a new window allowing you to change the 3rd tracked constellation between Beidou
and Glonass. Use the dropdown menu to change options and press the '
Save
' button to confirm.
Wi-Fi
The Wi-Fi area of the setup page displays the VBOX Sigma unit AP name and IP address, as well as external Wi-Fi
hotspot connection information. If you are intending to use an external Wi-Fi hotspot, such as a mobile phone or battery
powered hotspot to connect to the NTRIP sever, this can be configured by pressing the '
Change settings
' button next to
the Wi-Fi heading.
Simply enter the name and password of your hotspot and then press the '
Save and restart
' button. VBOX Sigma will
then re-boot and attempt to connect to the hotspot you have just configured. Once connected to the Wi-Fi hotspot, the
unit will briefly display a '
Wi-Fi Connected
' message.
Note: Only a 2.4 GHz Wi-Fi signal is supported, 5 GHz is not!.
To connect your phone/ PC back to VBOX Sigma, connect using the same hotspot and enter the new IP address which
will be displayed at the bottom of the screen. The page will update with the new settings and provide a connection status
indication. If VBOX Sigma cannot connect to the configured Wi-Fi hotspot on power, it will automatically restart and
become an access point so you can configure it again.
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_Sigma/VBOX_Sigma_User_Guide/04_-
_VBOX_Sigma_Configuration
21
