Racelogic LabSat 3, Руководство пользователя

Страница: 30 / 62

11 - LabSat3 Digital In/Out
For recording events from an external source, LabSat 3 is equipped with a digital input (DIGI) and digital output (DIGO)
which can be found on the expansion connector at the rear of the device. Digital input is pulled up externally to 5
V. Digital out is a 5 V level output. To enable the digital input for recording, go to
Menu > Setup > Digital > CH1 and
then enable the tick against ‘ Digi ’ in the signal list. Then, during recording, LabSat 3 will also record the state of DIGI
(pin3 of the expansion connector). During replay, the DIGO pin will output the recorded DIGI signal states.
https://racelogic.support/03LabSat_GPS_Simulators/LabSat_3/LabSat_3_User_Manual/
30