User’s Manual
35
4.2 Serial Communication
The RCM4200 module does not have any serial driver or receiver chips directly on the
board. However, a serial interface may be incorporated on the board the RCM4200 is
mounted on. For example, the Prototyping Board has an RS-232 transceiver chip.
4.2.1 Serial Ports
There are five serial ports designated as Serial Ports A, B, C, D, and E. All five serial ports
can operate in an asynchronous mode up to the baud rate of the system clock divided by 8.
An asynchronous port can handle 7 or 8 data bits. A 9th bit address scheme, where an
additional bit is sent to mark the first byte of a message, is also supported.
Serial Port A is normally used as a programming port, but may be used either as an asyn-
chronous or as a clocked serial port once application development has been completed and
the RCM4200 is operating in the Run Mode.
Serial Port B is shared by the RCM4200 module’s A/D converter, and is set up as a
clocked serial port. Since this serial port is set up for synchronous serial communication
on the RCM4200 model, you will lose the A/D converter’s functionality if you try to use
the serial port in the asynchronous mode. Serial Port B is available without any restrictions
on the RCM4210.
Serial Port C is shared with the serial flash, and is set up as a clocked serial port. PE7 is set
up to provide the SCLKC output to the serial flash, but PD2 also provides the SCLKC
ouput automatically when Serial Port C is used as a clocked serial port. Since this serial
port is available for synchronous serial communication on either RCM4200 model, you
will lose the serial flash’s functionality if you try to use the serial port in the asynchronous
mode.
NOTE:
Since Serial Port C is shared with the serial flash, exercise care if you attempt to
use Serial Port C for other serial communication. Your application will have to manage
the sharing negotiations to avoid conflicts when reading or writing to the serial flash.
Serial Port D may also be used as a clocked serial port. Note that PD0 provides the
SCLKD ouput automatically when Serial Port D is set up as a clocked serial port.
Serial Port E, which is available only on the RCM4210, can also be configured as an
SDLC/HDLC serial port. The IrDA protocol is also supported in SDLC format by Serial
Port E. Serial Port E must be configured before it can be used. The sample program
IOCONFIG_SWITCHECHO.C
in the Dynamic C
SAMPLES\RCM4200\SERIAL
folder
shows how to configure Serial Port E.
Содержание RabbitCore RCM4200
