IMPORTANT
INSTRUCTIONS
Phase Dimmer
TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF AT THE FUSE BOX BEFORE INSTALLATION.
●
To avoid risk of fire and electrical shock, products shall be installed in accordance with electrical code and regulations.
●
The product shall be used together with an air-break switch.
●
Cut off the power at the circuit breaker or fuse before installation.
●
If you’re not clear about any content of the instructions, please consult the licensed electrician.
●
Switch to the leading mode when the inductive load is used.
●
Product should only be used with compatible dimmable LED, CFL, incandescent or halogen products.
●
When connecting multiple products with a single dimmer, do not mix product types. All products shall be either dimmable
LED, CFL or incandescent products. Using the same type of products will enhance dimmer performance.
●
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
●
To avoid the risk of overheating and possible damage to the equipment, do not use the product to control the receptacle,
motor-operated appliance or a transformer-supplied appliance.
●
After installing the dimmer, it’s recommended to set the minimum brightness level to make bulbs turn on immediately and
the dimmer with maximum dimming range.
WARNINGS and CAUTIONS:
XDIM
WHAT'S IN THE BOX
Dimmer (1 pcs)
Jumper Wire
(1 pcs)
Mounting Screws
(2 pcs)
Base Plate
(1 pcs)
5PIN Wiring
Terminal (2 pcs)
2PIN Wiring
Terminal (3 pcs)
Connection Wire (5 pcs)
Face Plate
(1 pcs)
TOOLS NEEDED
5mm Philips Screwdriver
Electrical Tape
Electrician Knife
Test Pencil
Pliers
Ruler
●
●
●
●
●
●
