INSTRUCTIONS
FIELD-ADJUSTABLE TOMO™ INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
CANOPY KIT-TO-FIXTURE INSTALLATION
Cable
Junction Box
(sold separately)
Cross Bar
Locknut
Canopy
with Power
Cord
1/4- 20 Stud
Strain Relief
Canopy
Rings
Power Cord
Fixture
Cable Coupler
Cable Coupler Nut
Cable Coupler
Fig: 6
CANOPY-TO-SURFACE MOUNTING
1. Slide
Power Cord
through the hole on
Canopy
and tighten
with
Strain Relief
.
2. Connect wires per NEC and local code as shown in wiring
diagram
(Fig. 12)
. Push all wires back into the
Junction Box
. Be
careful not to pinch wires. Mount the
Cross Bar
on Junction
Box.
3. Mount the
Canopy
to the Junction Box. Push
Cable Coupler
on the
1/4-20 Stud
and tighten the
Coupler
.
4.
Canopy
and
Cable
without
Power Cord
can be mounted
with a
1/4 -20 Stud
and hardware appropriate to mounting
surface.
5. Push L
ens and Tray Assembly
into the
Housing Cover.
Align
Keys
into
Key Slots
and slide to the left to lock the
Housing
Cover
into the
Lens and Tray Assembly
. Snap on
End Caps.
WARNING: To prevent wiring damage or abrasion, do
not expose wiring to edges of sharp objects.
1.
Remove
End Caps
. Slide
Lens Tray Assembly
from
Housing
Cover
to release
Tray Assembly
by sliding the fixture to the
right to unlock from
Key Slots
as shown in Fig. 3. Pre-installed
Tether Cables
(2)
will prevent
Lens and Tray Assembly
from
separating from
Housing Cover
as shown in Fig. 1.
2. For
Canopy Mounting
, remove
(2)
Knockouts
on the
Housing Cover
as shown in Fig. 4.
3. Insert
Cable Couplers
from the inside of the
Housing Cover
through the two respective Cable Coupler
Knockouts
as
shown in Fig. 5.
4. Secure the
Cable Couplers
with
Cable Coupler Nuts
onto the
Housing Cover
as shown in Fig. 5.
5. Insert the
Cable
into the
Cable Couplers
. Adjust the length
of the
Cable
and tighten the
Locknuts
and trim any excess
cable inside the fixture.
6. Pull supply wires through
Power Cord Knockout
and make
connection inside the fixture.
Pass the
Power Cord
and Cable
through the
Canopy Rings
. Adjust the length of the
Power
Cord
and tighten it on the
Canopy
with
Strain Reliefs
(Fig. 6)
.
8. Mount all
Canopies
to the Fixture with appropriate
Cable
length.
9. Follow appropriate wiring instructions per NEC and local
code
(Fig. 12)
.
Cable
Tether Cable
Locknut
Cable Coupler Nut
Fig: 4
Knockouts
Fig: 5