VXBRLED INSTALLATION INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING:
Make certain power is OFF before installing or maintaining fixture. No user serviceable
parts inside.
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call
the Marketing Department at 888-RAB-1000, or email: [email protected]
Housing
Gasket
Housing
Housing
Screws (2)
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
Pat. Pending
WALL MOUNT
Fixture must be wall mounted. Use recessed or surface
mount junction box (not supplied) or use the
Housing
as
the junction box.
Fixture cannot be mounted upside
down in wet locations!
1.
Loosen
Housing Screws
and open
Housing
.
2.
Prepare back of
Housing
to use by knocking out
necessary mounting holes.
3.
Seal all gaps between wall and fixture with
weatherproof silicone sealant.
4.
Fixture may be wired through back conduit entrance
or side conduit entrance for surface mounting.
5.
Connect wires as shown in wiring section.
6.
Close
Housing
. Tighten screws and check
Housing
Gasket
seal.
7.
Seal all holes, plugs and conduit entrances with
weatherproof silicone sealant.
