MEGAFLOOD
TM
INSTALLATION INSTRUCTIONS
®
Page 1
SLIPFITTER MOUNTING
1. The slipfi tter fi ts a 2 3/8” O.D. tenon.
Place the
slipfi tter over the tenon and secure with the
(2) Set
Screws
on the side of the slipfi tter.
2. To adjust the angle of the fi xture:
a. Remove (2)
Cover Plate Screws
and the
Round Cover Plate
.
b. Hold the top of the fi xture, loosen the
Locking Bolt
and swivel the fi xture.
c. Tighten the
Locking Bolt
and re-attach the
Round Cover Plate.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. This product must be installed in accordance with the applicable installation code by a
person familiar with the construction and operation of the product and the hazards involved.
WARNING:
Make certain power is OFF before installing or maintaining fi xture.
Thank you for buying RAB lighting
fi xtures. Our aim is to design the
best quality products to get the job
done right. We’d like to hear your
comments. Call the Marketing
Department at 888-RAB-1000, or
email: [email protected]
TRUNNION MOUNTING
1. Mount fl oodlight to suitable fl at surface with adequate
hardware for that surface.
2. To adjust the angle of the fi xture:
a. Hold top of fi xture, loosen (2)
Trunnion
Bolts
and the
Positioning Screw
.
b. Swivel the fi xture until positioning screw is in
one of the
Positioning Holes.
c. Tighten the
Trunnion Bolts
and the
Positioning Screw.
Locking
Bolt
Set Screws
Round Cover
Plate
Cover Plate
Screws
Trunnion
Bolts
Positioning
Holes
Positioning
Screw
2.5”
3.5”
.Ø 0.532”
5.2”
2.53”
Ø 0.80”
