BULLET2X12 INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: For proper weatherproof seal, apply weatherproof silicone sealant around the edge of the Junction Box. This is
especially important with an uneven wall surface. Use silicone sealant on all plugs and unused conduit entries.
FIXTURE MOUNTING
Two BULLET12 heads come pre-wired and assembled on
CU4 plate,
allowing for mounting on round, rectangular
or octagonal surface or recessed junction boxes. Apply
weatherproof silicone sealant around the edge of the
Junction Box (not supplied)
. This is especially important
with an uneven wall surface.
1. Attach the
Universal Mounting Bar
with the screws
provided to the
Junction Box
. In case of surface mount
junction box, use with the
Metal Surface Plate.
2. Use the ‘S’ shaped hands free
Hanging Hook
to hold the
CU4 Plate
during wiring.
3. Bring power leads and BULLET12 head leads into
Junction Box
.
4. Strip off atleast 1/2” of insulation from all leads, and
insert through openings in
Metal Surface Plate
(if
used).
5. Attach ground wire to grounding screw on
Junction
Box
. Complete wiring as shown in wiring diagram
section.
6. Align
Gasket
,
CU4 Plate
and
Metal Surface Plate
(for
use with surface mounted junction boxes) to ensure
proper seal.
7. Tighten
Center Screw
(make sure
O-Ring Gasket
is on
the screw) to attach
CU4 plate
to the box. Check that
the
Gasket
is fully sealed.
8. Insert plastic
Finishing Cap
in the center of the
CU4
Plate
for a weatherproof seal. Use silicone sealant on all
plugs and unused conduit entries.
9. Aim BULLET12 heads in the desired direction and
tighten locknut and arm screw.
O-Ring Gasket
CU4 Plate
Gasket
Plug
Center Screw
Finishing
Cap
Metal
Surface
Plate
Hanging
Hook
Universal
Mounting
Bar
Bar
Screws
Junction Box
(not supplied)
.
