ANGSHARK ACCESSORY INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2015 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
Answered promptly [email protected]
ANGSHARK IN 1015
TROUBLESHOOTING
1. Check that line voltage at the fixture is correct. Be sure the fixture is grounded properly.
2. Refer to wiring, cleaning and maintenance directions on SHARK ™ (sold separately) Installation Instructions.
Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during installation operation
or maintenance.
ANGSHARK INSTALLATION
1. Use appropriate mounting hardware (not supplied) to secure the
Corner Bracket (2)
to
mounting surface as shown in
Fig. 1.
Bracket Tabs
must face towards each other. Recommended
Corner Bracket Distance
center to center is 13-5/16” (for 2 feet)
and 35-23/32” (for 4 feet).
2. Secure
Snap On Bracket (2)
(supplied standard with Housing) to
Corner Bracket (2)
with
Screws
provided as shown in
Fig. 1.
3. Snap
Housing
on
Snap On Brackets (2)
.
Snap On Brackets (2)
latch
onto the
Grooves
on
Lens
as shown in
Fig. 1
to secure
Housing
. Fixture installation should look like
Fig. 2
upon completion.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws and plugs inserted and
tightened firmly.
•
Apply weatherproof silicone sealant around the edge of the Housing. This is especially important with an uneven
ceiling surface.
•
Silicone all plugs and unused conduit entries and USE SHARK WITH CONDUIT ONLY.
•
FOLLOW ALL SHARK
™ (sold separately) INSTALLATION INSTRUCTIONS
Fig. 1
Corner
Bracket (2)
Screw
Bracket Tab
Distanc
e
Housing
Lens
Groove
Fig. 2
Mounting
Surface
Snap On
Bracket (2)
(supplied
standard w/
Housing)
