8
/ 34
User Manual
Rev. 1.0 - 04/12/20
TEX2503TFT
5. Installation and Configuration Procedure
Instructions are given in this chapter on installation and configuration of the
equipment. Carefully perform all the steps described in this chapter both upon
initial start-up and every time the main configuration is changed, for example when
moving to a new transmission station or when replacing the equipment.
IMPORTANT:
always disconnect the mains power before carrying out any type
of installation and/or maintenance. It is imperative to cut off the power supply to
avoid electric shock hazards that could cause damage to property and physical
harm, serious injuries or even death.
The equipment must only be installed by qualified personnel.
Qualified personnel are personnel who comply with all the safety directives, laws
and standards that apply to the installation and operation of this device.
The choice of qualified and duly trained personnel is always the responsibility of
the employer, since the employer is always the one in the best position to judge
whether a worker is suitable for a particular job and therefore capable of ensuring
their safety while respecting the applicable law on occupational safety.
Employers must provide their personnel with adequate training in electrical devices,
and ensure that they are familiar with the content of this manual.
Compliance with the safety instructions set out in this manual or with the legislation
indicated does not relieve the personnel from the duty to also comply with other
specific standards relating to the installation, place, country or other circumstances
concerning the equipment.
IMPORTANT:
there is a danger of possible electric shocks and it is therefore
mandatory to comply with the applicable safety law regarding electrical aspects.
Once configured, the equipment is ready for normal operation and no further
intervention is required since all the parameters are saved automatically for when
the equipment is switched off and on again either intentionally or unintentionally.
The performance and functions of the hardware and firmware of the equipment
are described in more detail in the following chapters: please refer to the relevant
sections of the manual for further information on what is covered in this chapter.
IMPORTANT:
during all phases of configuration and testing of the transmitter of
which this equipment forms part, always keep to hand the test table (“Final Test
Table”) accompanying the equipment: this document covers all the operating
parameters of the equipment set and checked at the time of testing after production.
