R.V.R. Elettronica 4CX7500, Техническое руководство

Страница: 13 / 82

Date: 25/07/03 R.V.R. Elettronica S.r.l. (BO) VJ10000-TE - R.F. Tube Amplifier
13
CHAPTER 1
VJ10000-TE GENERAL DESCRIPTION
1.1 MECHANICAL DESCRIPTION
The VJ10000-TE is allocated in a 19" rack, 40H, 7 of which are free and can be used to
insert an exciter, a receiver or any other equipment. Two analog instruments are placed on
the hinged frontal panel (
FIG. 1
) with all other controls and commands.
The rear panel (
FIG. 2
) hasn’t any connectors but only the air input for the cooling blower,
completed with the air filter and the hole for power supply and external exciters cables.
A chimney is placed on top section of the rack (
FIG. 3
) that allows to push out hot air. The
antenna connector is placed on the top part too. The type of connector for the ouput is 1"+
5/8 or 3” 1/8 (optional).
1.2 ELECTRICAL DESCRIPTION
The VJ10000-TE is a tube amplifier, with grounded grid configuration, working on the
frequency range 87.5-108 MHz.
This amplifier is able to operate at 10KW output power with a driving power of about 500
W. The amplifier has motorized plate, load and input tuning, and is able to cover the
completely frequency range. The VJ10000-TE is been projected to use a three-phases mains
voltage (monphase only on request).
1.3 TECHNICAL SPECIFICATIONS
See as reference the Table A for electrical specifications and Table B for mechanical and
enviromental specifications.
TABLE A - ELECTRICAL SPECIFICATIONS
Alternate mains voltage Three phases: 220-240V ±15%, 50-60 Hz
380-415V ±15%, 50-60 Hz
Mono phase: 220-240V ±15%, 50-60 Hz
Frequency Range 87.5 - 108 MHz
(other on request)
Output Power 11000 W max, 10000 W typical
RF Output Impedance EIA 1+5/8" connector, 50 Ohm
RF Input Impedance N-type connector, 50 Ohm
RF Driving Power 500 W max
Tube EIMAC 4CX7500
Cooling Forced air cooling
Spurious and harmonics suppression Exceed or equal to FCC an CCIR requirements
Power consumption about 18-20 KW