©
Copyright Qvis
Ⓡ
All software and documentation rights reserved.
55
Set sensor alarm parameters here: Enable detect, sensor type, detect time,
linkage alarm output, linkage output duration, E-mail sending when alarm
has been triggered, linkage snapping/recording, etc.
[Enable]:
Enable or disable sensor alarm detection.
[Sensor type]:
NO and NC mode.
[Time]:
Set the period of time for when sensor alarm
detection is active (two periods allowed).
[Linkage Alarm output]:
Supports Email, FTP, IO output, snapshot
and record.
[E-mail]:
Send sensor alarm message to users via
E-mail, details about E-mail setting please
refer to [Network Settings].
[IO output]:
Enable or disable linkage alarm output
[Alarm output duration]:
Set the duration after being triggered (in
seconds), the duration range can
be set between 0~86400s. 0 means that
there is no limit for alarm output.
[Snapshot]:
When alarm is triggered the pictures can
be saved via E-mail to a mailbox or uploaded
to an FTP server. In regards to the snapping
parameters; if the number of pictures
snapped at one time is set as 10, and the
snapping interval is set to 1 second, when
there is an alarm, 10 pictures will be snapped
and the interval between each picture is 1
second.
[Record]:
When alarm is triggered, the record files
will be saved to a specified FTP server.
After setting all the parameters, click ‘Save’ to make the parameters valid.
Attention:
Record file packet time equals the alarm duration, to set the
recording time duration see [Record] within the ‘Linkage Alarm Output’
section.
7.7.3
Network Detection
See Figure 39 for the interface of “Network Failure”:
