QVI Cobra DRS-300, Руководство пользователя

Страница: 54 / 100

Section 3
Getting Started
This section describes how to power up and shut down your Cobra system,
access the Scan-X software and its on-line Help, raise and lower the sensor,
perform a scan, and optimize laser settings.
Powering Up Your System
After unpacking your Cobra and installing the Scan-X software on the
associated computer (if applicable), you are ready to power up your Cobra
system.
To do so, follow the steps below.
1. Turn on the computer and monitor.
2. Turn on your Cobra. The power switch is located in the upper-right corner
on the Cobra back panel as shown in Figure 3-1.
3. Access Scan-X by using one of the following methods:
-
Double click on the
Scan-X
icon, located on the Windows desktop
-
Left click on the Scan-X icon, and then right click and select Open
from the pop-up menu
-
Click on the
Start
button, and then select
Programs Scan-X
Scan-X
Your Cobra system is powered up and ready to use.
Note: You can perform a normal system shutdown by exiting Scan-X and
Windows, turning off the computer and monitor, and then turning off Cobra.
Getting Started 3-1
Getting
Started
Figure 3-1. Power Switch Location