Note:
This setting immediately affects the video output. If the setting is modified during live playback, the
analog colorspace will immediately change to the new selection without needing to restart playback.
3.
Set
Analog Sync
to match the requirements of the display device.
Display devices may need a specific form of sync signal to show image properly. The type of sync
signal required is dependent upon the specific display device being used.
Select Audio Output Settings
1.
To use the front panel headphone jack or the Analog audio channels (1 and 2) to monitor any of the
digital audio channels, use the
LEFT or RIGHT Channel Mix
controls to route the digital audio
channel to the appropriate analog channel.
2.
Set
Master Frame Delay
.
This control is used to compensate for timing errors between video and audio normally caused by
external equipment that uses frame buffers while routing or converting video or audio.
3.
Set
Master Volume
.
This control is used to set the volume level for all audio channels.
4.
Set
Headphone Volume
.
Use this control to set the volume level for the headphone jack beneath the front panel bezel.
QuVIS Encore
Page 23
QSR Version 3.1
