1of2
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,
.
.
.
2017 QuoizelInc.
Assembly Instruction Sheet #IS-WKF9011EK
For Style WKF9011EK
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Package Contents
A
Mounting Screw
x 3
D
Fixture Body
x 1
Glass Panel
x 4
B
Fixture Hood
x 1
C
STEP 1
Install Glass Panels,
Bulbs and Fixture Hood
-
A. Unscrew screws from the top
edge of the Fixture Body (D) to
remove glass holder.
B. Insert Glass Panels (C) into the
slot in the bottom edge of the
Fixture Body (D). Attach the glass
holder onto the top edge of Glass
Panels (C) and align holes on it to
mounting holes on the Fixture
Body (D). Secure the glass holder
with removed screws. Tighten
gently until snug with
screwdrivers.
C. Insert bulbs onto sockets and
screw snugly into place.
D. Remove lock screws from the
Figure 1
ReleasedDate:2017-09-29
STEP 2
-
Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Fixture
Fitter
Marking Pen
Mounting
Hole
Post
Lighting
Post
Post
Fixture
Fitter
Figure 2
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Please go to
for product cleaning tips. Go to the
selection.
(3) B10 Candelabra Base bulbs 60W Maximum or
(3) Candelabra Base T8 Vintage bulbs are recommended but not supplied.
20-30 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
www.quoizel.com
Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Screw
Glass
Holder
B
C
D
Label “A”
Label “A”
Lock
Screw
T8 Vintage Bulb
(recommended
but not supplied)
Socket
Slot
(Step 1 Continued)
bottom edge of the Fixture Hood (B).
E. Align the label “A” on the top edge of the Fixture Body (D) to the
label “A” in the bottom edge of the Fixture Hood (B). Attach the
Fixture Hood (B) to the top edge of the Fixture Body (D) and secure
with removed lock screws. Hand tighten until snug with
screwdrivers.
STEP 3
M
C
E
M
H
-
arking the
enter of
ach
ounting
ole
A. Remove the light fixture. Using
the center punch and hammer
marking the center of each
mounting hole location that is
marked with the marking pen.
Center Punch
Hammer
Marking
Post
Figure 3
