Package Contents
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-WKF8409EK
_R1
For Style WKF8409EK
2017 QuoizelInc.
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
A
Crossbar Assembly
x 1
Please go to
for product cleaning tips. Go to the
selection.
(1) A19 Medium Base bulb 100W Maximum or
(1) Medium Base Vintage bulb is recommended but not supplied.
20-30 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
www.quoizel.com
Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Fixture can only be mounted in the direction indicated on page 2.
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
C
Fixture Body
x 1
B
Alternate
Mounting screw
x 2
D
Glass
Panel
x 4
E
Cage
x 1
STEP 1
Install Glass Panels
-
A. Unscrew screws from the top edge
of the Cage (E) to remove glass
holder.
B. Insert Glass Panels (D) into the slot
in the bottom edge of the Cage (E).
Attach the glass holder onto the top
edge of Glass Panels (D) and align
holes on it to mounting holes on the
Cage (E). Secure the glass holder
with removed screws. Tighten
gently until snug with screwdrivers.
D
Screw
E
Slot
Glass
Holder
STEP 2
Install Bulb and Cage
-
A. Remove lock screws from the Fixture Body (C).
B. Insert the bulb onto the socket and screw snugly into place.
C. Align the label “A” on the top edge of the Cage (E) to the label “A” in
C
E
Lock Screw
Vintage Bulb
(recommended
but not supplied)
Socket
Figure 1
Label “A”
Label “A”
STEP 3
Installing the Crossbar Assembly
-
A. Pass the supply wires through the Crossbar Assembly (A). Attach
the Crossbar Assembly (A) to the Outlet Box with the head of the
Green Ground Screw facing you. Secure the Crossbar Assembly (A)
with Outlet Box Screws (not included). Tighten until snug
Note: Use the Alternate Shorter Mounting Screw (B) if your
installation requires a shorter mounting screw.
.
Supply Wires
with Ground Wire
Outlet Box Screws
(not included)
Outlet
Box
A
Mounting Screw
or Alternate Short
Mounting Screw
Figure 3
the bottom edge of the fixture
hood. Attach the Cage (E) to
the fixture hood and secure
with previously removed lock
screws. Hand tighten until
snug with screwdrivers.
RevisedDate:2017-12-22
