Section 6-Hinging Rudder & Tail Wheel Installation
Required Tools and Adhesive
•
Xacto knife, #11 Blade
•
30-minute epoxy
•
Alcohol Swab/Alcohol and
paper towel
•
Wire cutter
Step 1
First place the plastic tail wheel
bracket on the tail wheel wire.
Figure 35
Step 2
Bend a 90-degree angle in the
correct direction on the tail wheel
wire that will be inserted in to a hole,
which you will soon drill into the
rudder. See Figure 36 that shows a
20mm distance from the 90-degree
bend to the bottom of the plastic tail
wheel-mounting bracket.
Figure 36
Step 3
Cut the wire that will go into the
rudder to about one inch in length.
Step 4
Drill a hole in the rudder for the tail
wheel wire 13 mm from the bottom of
the rudder.
Figure 37
.
19
Содержание Semi Scale Yak-54
Страница 34: ...Figure 82 Figure 83 34 ...
