Quinton MedTrack CR60, Руководство по обслуживанию

Страница: 30 / 92

4-2 Repair/Replacement and Calibration MedTrack CR60 Rehabilitation Treadmill Service Manual
Be sure treadmill area is free of liquid spills before
removing hood.
Burns
Warning! Allow pulleys, chain, motor, and other treadmill parts to
cool sufficiently before touching them.
Unplug the treadmill immediately if signs of overheating
occur.
Mechanical Hazards
Warning! Be sure the treadmill power cord is unplugged before
working with chains, rack gear, belt, and pulleys.
Secure long hair, loose clothing, and jewelry before
working near the treadmill, particularly near walking
surface and rotating parts.
Before running the treadmill, check for worn parts which
could break loose during service or operation.
Keep fingers away from rotating parts.
To avoid eye contaminants, clean away dust and debris
from moving parts before servicing.
Beware of sharp edges when replacing worn parts.
Do not start the walk belt when someone is on the
treadmill.
Improper lifting can cause back strain. It also can cause
injury to others if the treadmill is dropped. Lifting the
treadmill requires at least two people.
When removing the grade motor and chain, block the
treadmill headframe so that the deck will not drop to the
floor, causing injury and damage.
Tools
• Phillips and flat blade screwdrivers
• Hex wrenches: 5/32 in., 9/16 in., 7/16 in., 1/2 in., 5/16 in.
• 11/32 in. nut driver
• Heyco® strain relief pliers for replacing power cord
• 1/2 in. crowfoot open-end wrench for removing drive motor
• Torque wrench for rack gear replacement, 46± 4ft-lbs
• Frequency counter