Rev 1.0
Page 1 of 2
Air Control
Installation Guide
IT-AC-KIT which includes (
IT-AC-HUB-01
) and (IT-AC-SCREEN)
Overview
This document summarizes introductions for operating hub
IT-AC-HUB-01
. The
IT-AC-HUB-01
can remotely control the QuietCool Whole House Fans
of QC Manufacturing Inc at up to 3 different speeds.
Key Specifications
IT-AC-HUB-01
(Hub):
Voltage: 120V
Frequency: 60Hz
Motor load: 1HP, 735W (Max)
Warning:
- Disconnect power at the circuit breaker
before installing or servicing
- Use wires rated at least 105*C – copper
only
- Installation/wiring must be in accordance
with national and local code regulations
- Keep the enclosure cover closed at all
times when not servicing.
- Cover all unused wires with a wire
connector
FCC Regulations:
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution:
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
