Quidway S5000 series, Руководство по эксплуатации

Страница: 8 / 10

Operation Manual - VLAN
Quidway S5000 Series Ethernet Switches
Chapter 2 GARP/GVRP Configuration
2-4
z
Enable/Disable global GVRP
z
Enable/Disable port GVRP
z
Set GVRP registration type
In the above-mentioned configuration tasks, GVRP should be enabled globally before it
is enabled on the port. Configuration of GVRP registration type can only take effect
after the port GVRP is enabled. Besides, GVRP must be configured on the Trunk port.
2.2.2 Enable/Disable Global GVRP
You can use the following command to enable/disable global GVRP.
Perform the following configurations in system view.
Table 2-3 Enable/Disable global GVRP
Operation Command
Enable global GVRP gvrp
Disable global GVRP undo gvrp
By default, global GVRP is disabled.
2.2.3 Enable/Disable Port GVRP
You can use the following command to enable/disable the GVRP on a port.
Perform the following configurations in Ethernet port view.
Table 2-4 Enable/Disable port GVRP
Operation Command
Enable port GVRP gvrp
Disable port GVRP undo gvrp
GVRP should be enabled globally before it is enabled on the port. The GVRP can only
be enabled/disabled on Trunk port.
By default, port GVRP is disabled.
2.2.4 Set GVRP Registration Type
The GVRP registration types include Normal, Fixed and Forbidden (see IEEE 802.1Q).
z
When an Ethernet port is set to be in Normal registration mode, the dynamic and
manual creation, registration and logout of VLAN are allowed on this port.