1
How to in stall the HUD.
1. Stick Velcro strip to the center of product back.
2.Stick the products with velcro strip to the holder, post the holder toward auto front glass, confirm the reflecting
position once connect to the power from the automobile.
3. Clean the reflecting position of front glass by duster cloth, in order to stick reflecting sheet.
Reflecting Sheet sticking position guide:
Tip: Do not stick the reflecting sheet in front of the driver's sight, it will affect the driving behavior,
The best position is to the bottom in front of auto glass, or the middle or bottom of the both sides, not affect the driver
sight. Best position as below
4.Tear the protective layer of the reflecting sheet, spray some water to the tearing face of sheet in order to easy to
move during the sticking. Then stick the sheet to the reflecting location (note: the inside of the front glass).
5.After adjusting the sheet to the appropriate location, using a flat card to scrape the inside water until there are no
bubbles or water inside.
