9
QUICK SPA
INSTALLATION
EN
STRIP LED 12V - REV001B
Once a piece of STRIP LED has been cut, insert the two DRIVER STRIP LED wires in the POWER CAP. Solder the two wires
to the red copper plates, in correspondence of the cut of the STRIP LED.
ATTENTION: the side with shorter wires goes to Strip LED, the side with longer wires goes to Power Supply (see
picture to the pag. 10).
F
IMPORTANT -
RESPECT POLARITY WHILE SOLDERING:
THE STRIP LED DRIVER’S RED WIRE SHALL BE CONNECTED TO THE RED COPPER PLATE WITH THE “+” SYMBOL, AND THE STRIP
LED DRIVER’S BLACK WIRE TO THE RED COPPER PLATE WITH THE “
-
“ SYMBOL.
To connect the DRIVER STRIP LED please follow the instructions at the pag. 10.
L14
L15
R5
L16
L11
L12
R4
L13
L10
The other end should be closed by means of the silicone ENDING CAP.
L11
L12
R4
L13
L10
L11
L12
R4
STRIP LED
DRIVER
STRIP LED
POWER CAP
ENDING CAP
Any additional STRIP LED DRIVER and CAPS needed to personalize the installation of STRIP LED 12V are not included in the
packaging. Contact Quick
®
making reference to the following part numbers:
DRIVER STRIP LED
KCAD20SLSUP0
POWER CAP
PCCSLPWR0000
ENDING CAP
PCCSLEND0000
In order to close the POWER CAP, a neutral (non-ace-
tic) silicone should be used.
The cap should be filled with silicone, and then insert-
ed into the STRIP LED.
In order to close the ENDING CAP, a neutral (non-ace-
tic) silicone should be used.
The cap should be filled with silicone, and then inser-
ted into the STRIP LED.
THE POWER CAP
and the ENDING
CAP guarantee the
RATING
Содержание STRIP LED 12V
Страница 2: ......