Quest Engineering MPS 3, Руководство по эксплуатации, Страница: 41 / 268

MPS 3 System – Warnings and Cautions
4.5. System Cleaning
•
DO NOT immerse unit in any kind of ultrasonic bath, disinfectant, cleaning solution, or any
kind of liquid. Do not spray liquids directly onto the MPS 3 System and prevent liquids
from entering the Console and Controller as this may short-circuit the internal electronics
and can cause potential hazard for operator and/or patient.
•
DO NOT USE bleach or any chlorine based cleaning solutions in the MPS 3 circulation
system. Chlorine may compromise heat exchanger integrity resulting in water to blood
leakage and possibly patient injury.
•
DO NOT USE any kind of chemical solvent, acidic, or alkali solution. Use neutral detergent
or isopropyl alcohol on a clean soft cloth to clean the MPS 3 Controller display panel
surface.
•
If the buttons on the Controller do not respond to input, the display panel may need to be
cleaned. Clean the MPS 3 display panel as indicated in the cleaning section of this
manual. If the problem persists, contact Quest Medical customer support.
4.6. System Alarms
Alarms indicate failure or malfunction of a component in the MPS 3 System and notify
the operator to take the proper action to resolve the alarm condition. Alarm messages
are displayed in the message window and proper action is required from the operator.
The MPS 3 System alarms are classified as follows:
•
High priority alarm
•
Medium priority alarm
•
Informational signal
For more information about Alarms and their corrective actions, refer to Section 10: Alarm
overview and Section 11.3: Error Code List and Solutions.
Please read all warnings and precautions before using the MPS 3
System. It is important to understand all safety messages that follow
in this section to avoid potential injury or harm to the operator and/
or patient and avoid unintended damage to the MPS 3 System.
11