Quest Engineering MPS 3, Руководство по эксплуатации, Страница: 31 / 268

MPS 3 System – Warnings and Cautions
4. Warnings and Cautions
4.1. General Warnings and Precautions
•
For Professional Use Only.
•
The MPS 3 System must be attended at all times during the procedure.
•
It is important to observe the following precautions with the standard safety procedures as
well the specific safety recommendations presented in this Operations Manual.
•
USE ONLY QUEST MEDICAL AUTHORIZED SERVICE TECHNICIANS . Quest Medical,
Inc. cannot assure safe operation of the MPS 3 System if it is serviced by anyone other
than an authorized service technician. Unauthorized service voids all warranties.
•
Use of the device is restricted to professionally trained personnel in accordance with the
instructions below.
•
The battery should only be serviced or replaced by Quest Medical authorized service
technicians.
•
DO NOT operate the unit in the proximity of flammable mixtures; the MPS 3 system is not
suitable for use in the presence of a flammable anesthetic mixture with air or nitrous oxide.
Use in well-ventilated area.
•
Keep solvents, flammable liquids, and sources of intense heat away from the MPS 3
System as they may damage internal and external parts and compromise the integrity of
the device.
•
Before use, inspect the MPS 3 System for signs of physical damage or deterioration.
Specific areas to inspect include the inner door latches for proper locking, Controller
display panel surface and control knobs, the mechanism boot (surface where cassettes
are installed) for tears and separation, and the power cabling for deterioration of insulation
or bare wires. If a problem is identified, DO NOT USE the MPS 3 System. Call an
authorized service representative from Quest Medical for correction.
Prior to installation and activation of the MPS 3 System, the operator shall
consult the instructions for use for the equipment and accessories carefully to
avoid injury. The operator shall comply with the following safety procedures as
well as the safety comments and recommendations presented throughout
these instructions for use. The manufacturer accepts no liability for any
damage resulting from the improper use of this equipment and/or for any
purpose other than those covered by these instructions.
Please read all warnings and precautions before using the MPS 3
System. It is important to understand all safety messages that follow
in this section to avoid potential injury or harm to the operator and/
or patient and avoid unintended damage to the MPS 3 System.
The MPS 3 System has been designed and tested to meet the
requirements of electromagnetic, electrostatic, and radio frequency
interference standard. However, the possibility of electromagnetic or
other interference may still exist. When experiencing interference,
relocating the system may help to eliminate any interference.
1