Wi-Fi&Bluetooth Module Series
FC41D-TE-B User Guide
FC41D-TE-B_User_Guide 21 / 24
4
Operation Procedures
This chapter introduces how to use the FC41D-TE-B to test and to evaluate FC41D.
4.1. Power on FC41D
1. Connect the TE-B to PC via USB cable.
2. Switch J104 (Power Switch) to ON state, then D407 (VBAT ON/OFF indicator) will light up.
4.2. Communication Via UART (USB Connectors)
1. Power on FC41D according to the procedures mentioned in
Chapter 4.1
.
2. Connect the USB connectors of FC41D-TE-B to PC with the USB cable, and the USB serial port
number can be viewed through the PC Device Manager, as shown below.
Figure 13: USB Serial Port
3. Install and then use the QCOM tool provided by Quectel to achieve the communication between the
module and the PC. The following figure shows the COM Port Setting field on QCOM: select correct
“
COM port
” (USB Serial Port) and set correct “
Baudrate
” (such as 115200 bps). For more details
about QCOM tool usage and configuration, please refer to
document [1]
.