QUBINO FLUSH SHUTTER DC, Руководство пользователя

Страница: 36 / 59

EN .
36
11. Removing the device from a Z-Wave network
(Exclusion)
REMOVAL FROM A ZWAVE NETWORK (Z-WAVE EXCLUSION)
1. Connect the device to the power supply
2. Make sure the device is within direct range of your Z-Wave gateway (hub) or use a hand-held
Z-Wave remote to perform exclusion
3. Enable add/remove mode on your Z-Wave gateway (hub)
4. Toggle the switch connected to the I1 terminal 3 times within 3 seconds. The device has to get
On/Off signal 3 times, meaning 3 times push of the button or with the normal button 3 times
On/Off.
OR
Press and hold the S (Service) button between 2 and 6 seconds
5. Exclusion with the switch connected to I1 terminal is not limited by time
6. The device will be removed from your network but any custom configuration parameters will
not be erased
FACTORY RESET
1. Connect the device to the power supply
2. Within the first minute (60 seconds) the device is connected to the power supply, toggle the
switch connected to the I1 terminal 5 times within 3 seconds (5 times change switch state). The
device has to get On/Off signal 5 times, meaning 5 times push of the button or with the normal
button 5 times On/Off.
OR
Press and hold the S (Service) button for at least 6 seconds
ⓘ
By resetting the device, all custom parameters previously set on the device will return to their
default values, and the node ID will be deleted. Use this reset procedure only when the main
gateway (hub) is missing or otherwise inoperable.