QUBINO FLUSH SHUTTER DC, Руководство пользователя

Страница: 35 / 59

EN .
35
10. Adding the device to a Z-Wave network (Inclusion)
AUTOMATICALLY ADDING THE DEVICE TO A Z-WAVE NETWORK (AUTO INCLUSION)
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Automatic selection of secure/unsecure inclusion
3. Connect the device to the power supply (with the temperature sensor already connected –
sold separately*).
4. Auto-inclusion will be initiated within 5 seconds of connection to the power supply and the
device will automatically enrol in your network
NOTE: the device can be automatically added to a Z-Wave network during the first 2 minutes
after connected to the power supply.
MANUALLY ADDING THE DEVICE TO A Z-WAVE NETWORK (MANUAL INCLUSION)
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected*)
3. Toggle the switch connected to the I1 terminal 3 times within 3 seconds. The device has to
get On/Off signal 3 times, meaning 3 times push of the button or with the normal button 3
times On/Off.
OR
Press and hold the S (Service) button for at least 2 seconds
4. A new multi-channel device will appear on your dashboard
5. Inclusion with the switch connected to I1 terminal is not limited by time
*If connecting the temperature sensor, switch off the power supply and make sure the device is
excluded from your network BEFORE connecting the sensor.
ⓘ
Make sure the device is excluded from your network before connecting the temperature
sensor. Switch off the power supply, connect the temperature sensor, and re-include the device
to your network.