Quasar Science Rainbow 2, Быстрый старт

Страница: 30 / 185

Lead/Follow Mode
Lead/Follow mode allows one light to control many lights at once. The Lead transmits color and intensity data, wired or wirelessly, to the Follows. When the Lead
changes levels, the Follows will change as well. This applies to on board FX as well.
To use Lead/Follow mode, go to Config -> Lead/Follow. Set the leader to Lead and set all of the followers to Follow 1 to match the leader. Follow 2-8 are used
with effects to do the same effect with different timings. This will run the same effects, intensities and levels but not in sync.
To use Lead/Follow wired, plug a Cat5 cable into the DMX OUT port of the leader into the In of the followers. Repeat out of the followers and into the next. The Data
light should be illuminated on all the followers.
To use Lead/Follow wirelessly, after setting to Lead or Follow 1-8, set Wireless Mode to “CRMX”. Then on the follows, press and hold to unpair the light. Next
tap on the leader. On all of the followers, the Wireless signal light should begin flashing and then remain solid. Learn more about Lead/Follow status light color
combinations [19]
NOTE
Lead/Follow is for manual operation only and cannot be used with DMX.
Rainbow 2
30