Quark-Elec Manual
https//www.quark-elec.com
9 of 15
2016
V1.0
5 W
I
F
I CONNECTION
QK-A023 Version2.0 support both Ad-hoc mode and station mode. The module will work in Ad-hoc
mode by default but it can be easily setup to station mode through GUI.
Figure 9WiFi Antenna
5.1 Ad-hoc mode
15 seconds after QK-A023 has been powered up, the operator should be able to scan and find a WiFi
network (SSID) similar to „QK-A023xxxx‟ using WiFi enabled devices such as computers, mobile
phones or tablets.
Connect the device/s to „QK-A023xxxx‟ with „88888888‟ as the default password. Set the protocol as
„TCP‟, IP address as „192.168.1.100‟ and the port number as „2000‟ in the chart software.
Item
Setting
SSID
Similar to „QK-A023xxxx‟
Protocol
TCP
IP address
192.168.1.100
Port
2000
With the above settings, wireless connection should be set and the operator will be able to receive the
AIS messages through the chart software. the operator can always check the wireless connection
with TCP/IP port monitoring software as shown below:
