Quantum StorNext M330, Руководство по оборудованию

Страница: 36 / 60

Chapter 3: Basic System Operations
Powering On All StorNext M330 System Components
32 StorNext M330 Metadata Appliance Hardware Guide
Powering On All StorNext M330 System Components
Figure 15 on page 33 illustrates the location of the power switches, and
the specific order to follow when powering on the StorNext M330
system components.
Note: Before continuing, verify that all power switches on every
component are in the OFF position.
1 Turn on both power switches on the back of the Metadata Array.
Note:
Before powering up the MDC Nodes, make sure that the
Metadata Array drive LEDs are all green, and the seven-
segment display on the Metadata Array indicates “85”. This
indicates that the Metadata Array is ready for I/O. The
system is then ready for powering up the MDC Nodes.
2
Turn on the power switch on the front of each of the MDC Nodes.
Callout number 3 in Figure 15 on page 33 shows the location of the
power switches and the power on sequence.