Quantum PX720, Руководство пользователя

Страница: 62 / 259

Chapter 1 Library Description
Getting Started
Quantum PX720 User’s Guide 39
6 To edit the setup information, use the up and down arrows to
highlight the section and press
Select
.
• To set the IP address, subnet mask, and gateway, use the up and
down arrows to select the appropriate number and press
Select
to accept.
• To enable/disable DHCP, use the up and down arrows to toggle
between enable/disable. Press
Select
to accept the setting. If your
library is not connected to a network which uses a DHCP server
to assign IP addresses, disable this function.
• To change the password, use the up and down arrows to select
Change Password and press
Select
. To change the password,
enter a 6-digit password using the numbers provided on the
OCP. Press
Select
to accept the new password. When prompted,
re-enter the password to confirm.
• To enable drive autoclean, use the up and down arrows to select
Drive Autoclean and press
Select
.
• To enable drive autounload, use the up and down arrows to
select Drive Autounload and press
Select
.
• To enable the left load port, use the up and down arrows to select
Left Load Port (16) and press
Select
.
• To enable the right load port, use the up and down arrows to
select Right Load Port (32) and press
Select
.
7 When you are finished viewing/editing the setup information, press
Back
twice to return to the
Home
screen.
8 From the
Home
screen, press
Ops
to enter the operations screen.
9 Before the network information can become active, the cabinet must
reboot. To reboot the cabinet, use the up and down arrows to
highlight the cabinet and press
Select
.
10 Use the up and down arrows to select the reboot option and press
Select
.
The library reboots.
The library is now ready for operation. For more information on
Quantum PX720 remote management, see chapter 3 on page 86.